Satellites cannot be programmed into this receiver, the customer will have a list of satellites with the corresponding dish position number.

To move the dish east or west. Press SAT, then use up/down arrows to move the dish in appropriate direction. The range is from 0 to 255. After moving the customer will need to press CHAN to enable the up/down buttons to change channels again.

To auto tune the dish, press SAT , then F-TUNE. When the best picture is found, have the customer remember the position number.

To reverse polarity. Press the FORMAT button on the remote.

To adjust the skew. Use the SKEW up/down button to adjust. The skew will be displayed on the screen while adjusting. The changes are stored automatically.

To video fine tune. Press the F-TUNE button on the remote. "FIN" will come up on the receiver display. Use up/down buttons to adjust the video.

To change the audio. Press the FREQ button to display the current audio frequency. Press FREQ, then direct enter the desired audio frequency, or use the up/down buttons to tune the frequency, or press SEEK to search for a frequency.